What alarm panels can I use with the IPalarm transmitter?

Virtually every alarm panel on the market.  The IPalarm transmitter uses the telephone line output and works as a dial capture device. Just program your alarm panel to use contact ID, and that’s it.

Click to Select Product Support

IPalarm IP-Wi-Fi Internet Transmitter

Alarm Panel Connection Guides for Most Popular Brands

Remote Arming Setup & Use Instructions

 

 

 

 

 

 

WIRING COLORS: RED – AUX POSITIVE, DARK GRAY – AUX NEGATIVE, GREEN – RINGYELLOW – TIP.

Make sure your panel has a 12 VDC power supply. If not, you may need to install one!

REMOTE ARM / DISARM PROGRAMMING 

The M2M-MINI comes with a FREE APP from M2Mservices to offer your clients remote arm / disarm from any smartphone!  

The FREE app will not have your company logo on it unless you order a “PRIVATE M2M PORTAL” from VirtuAlarm.  Once you do have a private portal, all your M2M devices will be placed into your private portal to allow a broader display and control of your devices as well as have your company logo placed on it.

Compatible panels for this feature must have:

  • A programmable momentary keyswitch zone

  • A programmable armed status output

  • Open and closing reports must be turned on

Wiring this feature is simple. The orange wire goes to your momentary keyswitch zone, the white wire goes to your “armed status output”.

NOTE: Some panels might require EOL resistor on the key switch zone for remote arming. Simply put your EOL across the ground and zone, and put your orange wire on the zone input.

Have your client download the app: RControl. Simply open it up and follow the instructions!

NOTE: The Open/Close signals must be enabled every time you want to allow remote Arming/Disarming. Once the device is synced with the RControl App you can disable the Open/Close reporting if needed.  

M2M L.E.D. Indicator

▪ Slow flashing – trying to establish connection
▪ Constantly On – connection established at good signal level
▪ Constantly On, blinking every 5 sec – connection established at low signal level
▪ Fast flashing – transferring data

You can also view your M2M-MINI on line for connection status using or FREE M2M PORTAL or PRIVATE M2M PORTAL 

 

Configuring the Alarm Panel for a M2M-MINI 

Refer to the panel’s installer manual to configure the following options:
▪ Enable the PSTN dialer of the panel
▪ Select DTMF mode (Tone dialing)
▪ Select Contact ID Full communication format
▪ Enter a telephone number for dialing (you can use any number, e.g. 9999999)
▪ Enter a 4-digit account number in the panel.

Also See Multiple Alarm Panel Wiring Diagrams Below